Driving Directions to Workshop from Santa Fe

To Los Alamos area from Santa Fe

Also see general maps of approaches to Los Alamos.

Take US 84/285 (St. Francis Drive) north to Pojoaque (20 mi / 32 km).
At Pojoaque, take the NM 502 exit. Drive west on NM 502 to the NM 4 interchange (8 mi / 13 km).
Take the NM 4 exit (Truck route/White Rock/Bandelier) and drive southwest (1 mi / 1.6 km) to the light.
Turn right at the light (East Jemez Road) and drive the truck route to Los Alamos National Laboratory at the first traffic light (5 mi / 8 km).

All non-US citizen visitors must proceed directly to the badge office to receive your badge.

Go straight through the light. Take your first left into the main parking lot.
Follow the signs to the Badge Office, and park in the short-term parking. Proceed to the badge office.

If you are in the badge office, proceed out of the parking lot, turn right onto Jemez Road. Turn right at the light onto Diamond Drive.
If you did not go to the badge office, and are already at the traffic light, turn left at the Light into Diamond Drive.
Turn Left at the next light. To get to the Center for Material Science, use the parking lot IMMEDIATELY after the light. Building SM-32 is right there.
Note: Tuesday afternoon we will meet in a nearby room. By car, continue on diamnod drive past the light that leads to the Center for Material Science, and then take the first left. You will see the Material Science Laboratory (SM-1698). Park there and take the main door.